A conditioning and nourishing solid shampoo bar featuring Cupuaçu Butter and cationic emulsifiers. Stage 1 (above 60°C) 55% Sodium Cocoyl Isethionate 20% Beta T 10% Emulsifying Wax (BTMS 25) 5% Cupuaçu Butter 2.5% Conditioner Emulsifier 2.5% Hot Bottled Water 0.5% Lactic Acid / Citric Acid Stage 2 (below 40°C) 2% D-Panthenol 1.5% Essential oils of your choice 1% Preservative Eco 100% Total Sold out Sold out Sold out Sold out Sold out Sold out Sold out Sold out Sold out Method ● Weigh out the SCI chips and grind them to a fine powder in an electric coffee grinder. Make sure you wear a suitable face mask and do not breathe the dust in. ● Combine all Stage 1 ingredients in a stainless steel pan or bowl and place directly onto the hob on very low heat. ● Allow the heat to gently begin softening the ingredients. After a few minutes stir the mixture very gently to help the heat spread through the ingredients. ● The SCI Powder and emulsifiers can take quite a while to melt so have patience, stir gently every few minutes and watch that the mixture does not get too hot and burn. ● When the surfactants etc have become translucent remove from the heat and allow to cool a little before adding the Stage 2 ingredients. ● Although these are heat sensitive they will not be exposed to high heat for long so will be ok. ● Once the Stage 2 ingredients are fully combined, scoop the mixture into moulds press down to fill the moulds completely then place in the fridge to cool fully and set. ● When set, remove from the mould and allow to air harden for a few days before using. You can use the shampoo bar immediately if you wish but it will be softer and not as long lasting.